Plasmon LF 6602, Руководство пользователя, Страница: 61 / 103

97654438 E
Page 61
5) Press the SELECT switch to scroll through the states for CDE Curs (on, off). When the
desired state is displayed, press MENU to enter the state and move to the next option in
the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.
SETTING THE BUSY OPTION
When the enabled, the “Busy” message is displayed at the DOC during a spin up or spin down operation.
The “Busy” message will also be displayed when a command that cannot be stored for later execution is
being executed.
Perform the following procedure to enable or disable the BUSY option.
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "Busy:" is displayed.
5) Press the SELECT switch to scroll through the states for the load switch (on, off). When
the desired state is displayed, press MENU to enter the state and move to the next
option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.
SETTING THE
MODSEL
RA OPTION
When the enabled, the (Mode Select Read Ahead) ModSel RA option allows the LaserDrive to continue
reading sequentially after a READ command has been completed.
Perform the following procedure to enable or disable the ModSel RA option.
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "ModSel RA:" is displayed.
5) Press the SELECT switch to scroll through the states for the load switch (on, off). When
the desired state is displayed, press MENU to enter the state and move to the next
option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.