Plasmon LF 6602, Руководство пользователя

Страница: 57 / 103

97654438 E
Page 57
SETTING THE SCSI ID
The SCSI ID can be set to one of eight device Identification (ID) numbers (0 through 7); however, each
device connected to the same SCSI bus must have a different SCSI ID.
Perform the following procedure to set the LF 6600's SCSI ID number:
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "SCSI ID" is displayed.
5) Press the SELECT switch to scroll through the options for the SCSI ID value
(0,1,2,3,4,5,6,7). When the desired value is displayed for the SCSI ID, press MENU to
enter the SCSI ID value and move to the next option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.
NOTE
After resetting the device ID, turn the drive off, wait 1 sec and then
turn the drive on again. This ensures that the new device ID will be
acknowledged by the SCSI bus.
SETTING THE BUS PARITY CHECKING
SCSI bus parity generation is always enabled; however, SCSI bus parity checking at the drive can be
disabled.
Perform the following procedure to turn parity checking on or off.
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "Parity:" is displayed.
5) Press the SELECT switch to scroll through the states for parity checking (on, off) When the
desired state is displayed, press MENU to enter the state and move to the next option in
the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.