Copyright Planika Sp. z o.o.
www.planikafires.com
9
Information and warning alerts
Lp.
Control Panel
Indicators
SOUND
SIGNALS
Event
Procedure
cons
t
ant
inter
mi
ttent
1
If the fire is not visible - NO
POWER.
Make sure the device is properly connected to the power
supply.
If you see a fire - the device is
in operation.
Do not leave the device unattended by an adult.
2
The device is ready for
operation.
You can run the device in accordance with section B.3
3
No fuel in the tank
Fill the fuel in accordance with B.2 paragraph
4
Initial start-up of the device
Wait for the appearance of fire, the light goes off.
5
Works protected against too
rapid restart of the hot device
or the allowable temperature
has been exceeded
Allow the device to cool down. After cooling the device,
the red indicator will turn off and the green indicator will
start to flash.
6
The device automatically
turns off due to lack of fuel in
the tank.
Allow the device to cool down. After cooling the device,
the red indicator will turn off
7
The device is ready for
refuelling.
Fill the fuel in accordance with B.2 paragraph.
8
×
The fuel tank is full (with
intermediate sound).
Disconnect the fuel hose. Close the filler bolt.The blue
indicator will turn off, the green one will start to flash.
9
×
There was a fuel spill or
If refueling process is in progress it will cease
automatically. Disconnect the automatic pump. Press the
START / STOP button on the control panel to turn off the
sound.
If the spillage is excessive the source of power
needs to be disconnected
Wait at least 1 hour to
evaporate the remaining moisture and then close the
fuel filler bolt. If the alarm message reappears, wait a
little bit longer until the rest of the moisture evaporates.
If the message reappears, contact your service provider.
The time given for the flame
to appear has been exceeded
If the alarm message appears during the start of the
device, press the START / STOP button to turn off the
sound and hold the ECO button for about 5 seconds.
If the message reappears, contact your service provider.
10
×
Operation error
Press the START / STOP button to turn off the sound and
hold the ECO button for about 10 seconds.
If the message reappears, contact your service provider.
11
×
The device temperature
below 10°C or critical
operation error
Press the START / STOP button to turn off the sound.
Provide higher ambient temperature. Wait until the
device obtains the indoor temperature. Hold down the
ECO button for about 10 seconds.
If the message reappears, contact your service provider.
12
×
Too much liquid in the tank
Shut the filler bolt. Press the START / STOP button to turn
off the sound and hold the ECO button for about 10
seconds. If the message reappears, contact your service
provider.
13
×
Fuel filler lid opened
during start up sequence
or work of the device
Shut the filler bolt. Press the START / STOP button to turn
off the sound and hold the ECO button for about 10
seconds. If the message reappears, contact your service
provider.
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
