Copyright Planika Sp. z o.o.
www.planikafires.com
7
After closing down the fuel filler flap the LED lights on
PrimeFire
will indicate:
−
PrimeFire
is ready to use,
or
−
Too little fuel was pumped, repeat refueling.
3.
Starting the device. The green indicator
flashes on the control panel .
3.1. Press the
START/STOP
button on the control panel and hold it until you hear the sound signal.
3.2 The green led READY will start blinking to indicate starting the device and the filament will start to glow. Wait until
the fire appears.
3.3. While the appliance is in work mode, the green indicator goes off and the flame starts to appear. The device works
automatically until they run out of fuel or disable the device by the user.
Depending on the temperature and amount of fuel, the startup sequence may take up to 10 minutes. When the LEDs are off, they
will go out.
C.
Flame size regulation
The
PrimeFire
can operate in two modes: Normal and ECO. The device always starts with a standard flame size. The device has the
adjustable flame size during operation.
In order to reduce the height of the flame, press the ECO button. You will hear two beeps and the ECO button will be highlighted.
The unit is now operating in ECO mode.
To return to the normal height of the flame, press the ECO button, you will hear one beep and the ECO button backlight turns off.
The device is now in normal mode.
ATTENTION!
It might take a few moments for the flame to adjust.
ATTENTION!
The device switches to ECO mode by itself when there is a danger of over-temperature of the device.
D.
Device extinguishing
Press the
START/STOP
button on the control panel. You will hear two beeps and the red indicator
will start to blink.
The blinking red indicator means that the device is too hot to be restarted. When the device cools the message will disappear, and
depending on the amount of the fuel in the tank, either the green indicator will flash and indicate the readiness for operation or
the blue indicator will indicate the lack of the fuel.
E.
Subsequent start up
If on the control panel flashes the blue FUEL
indicator, start to run the product from the point B.2.
If on the control panel flashes the green READY
indicator, you can:
•
start to run the product from the point B.3.
•
fill the fuel in accordance with B.2 paragraph.
READY
F U E L
READY
HOT
F U E L
READY
During pouring be careful not to spill out the fuel. If the fuel is spilled error message
may be displayed.
Go to step F, and follow the guidance provided in the table.
If the spillage is excessive the source of
power needs to be disconnected.
READY
FUEL
HOT
