Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
28
WARNING!
You should avoid leaving fingerprints on the glass. They will be burned out on it after the device starts
working and you will not be able to remove them. The frequency of cleaning the glass should depend on the
assessment of the contamination degree but not less frequently than once every six months (in the case of LPG-
powered fireplace: not less than once a quarter).
11.2.
Assembly of the glass
The device is equipped with heat-resistant ceramic glass to withstand temperatures up to 800 ° C. Depending on the
glazing of the unit, disassembly and assembly of the front glass takes place in a different way.
WARNING!
Avoid leaving fingerprints, because they will burn out on the glass.
To mount the front glass of the device with the front glazing you must:
•
Make sure the glass is clean, free from persistent dirt and fingerprints.
•
Carefully mount the suction cup in the middle of the glass.
•
Holding the glass at angle, insert its upper edge between the body of the fireplace and the horizontal fixing
strip (1).
•
Slide the glass upwards so that its lower edge is above the lower decorative frame "D" (2).
•
Push lower edge of the glass in the direction of the body of the fireplace so that the surface of the glass is in
vertical position (3).
•
Move the glass down and carefully set its bottom edge inside the horizontal handle.
•
Even out horizontally position of the front glass relative to the side walls so that the side edges of the front
glass comport with the vertical edges of the side walls.
•
Move the horizontal strip fixing front glass "C" (4) to the right until it stops and tighten it with screws "B" (5).
•
Make sure that the screws are not tightened too much, because it can then lead to their breakage or damage
of the thread.
•
Mount the side pressure strips "A" in the holes in the side frame and by pushing them down, lock in the vertical
position (6).
•
Remove the suction cup.
