Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
20
WARNING!
If you select the automatic mode of controlling the fireplace, it is important that the remote control is not
in the immediate vicinity of the fireplace and lay freely in easily accessible location. This will allow you to avoid passing
incorrect information by the thermometer (integrated in the remote control) to receiver controlling the operation of
the fireplace, about the temperature in the room.
8.1.1.
Ignition of the device
To start the process of firing the device, which is ready for use in manual
mode, simultaneously press and hold for at least 2 seconds
and
buttons on the remote control. The gas supply to the furnace will open and
you will hear the sound of working ignition electrodes.
During the ignition on the screen of the remote control, symbols
and
will start flashing, which indicates the fact that, the ignition process of the
device is taking place and you will also see the hourglass symbol, which will
not let you manipulate the fireplace. In the first place the middle section of
the device will be lit on 50% of its power. After about one minute solenoid
valve gas supply turns on to the side section of the furnace and the device
switches to its full performance. The hourglass symbol will disappear which
indicates the end of the ignition process.
WARNING!
If there is no ignition of the device after three restarts and the permanent device lock activates, it may be
impossible to reset it by disconnecting the power source. In such cases, contact your dealer or installer.
When the symbol
on the screen will disappear and symbol
will stop
flashing, it means that the ignition of the device was completed correctly, and
the fireplace is ready to use. From that point on, manual flame height
adjustment will be possible.
