Copyright Planika Sp. z o.o.
www.planikafires.com
IG0058#00
31.03.2017
27
24 hour control
Reset using the remote control
F15
No automatic control
ESYS
Loosening of the automation
control
Fix the automatic control
Not properly installed automatic
control
Install properly automatic control
Upper Limit error
Electrodes by the
gas adjustment block connector
are bent
Straighten them
Damage to the bridge of the
upper limit
Check the bridge of the upper limit
ESYS
F16
Hardware failure ESYS Damage ESYS (burner module)
Exchange ESYS (burner module)
11.
MAINTENANCE
WARNING!
The device should be maintained and serviced by a competent installer.
At least once a year the unit should be checked in order to operate properly and safely. The device cannot be used in
case of damage or glass breakage. In this case, close the gas valve and immediately have the glass replaced. Do not
change the design and sealed components or modify factory settings of the device under no circumstances.
The user can clean the exterior of the device, without using for this purpose corrosive and aggressive detergents. The
warranty does not cover damage to the paint resulting from mechanical damage eg. falling objects or placing them at
the border of the device.
11.1.
Cleaning of the glass with anti-reflective coating
WARNING!
The glass must be removed and cleaned only when it is cooled down to room temperature, and the device
is turned off.
To prevent damage to the coating layer on the anti-reflective glass is prohibited to use hard sponges, steel wool,
abrasive cleaners and cleaning products containing ammonia.
Most of the sediments formed on the glass can be removed with a microfiber cloth. Other materials, such as paper or
kitchen towels, etc., may cause scratches and in the case of anti-reflective glass can also cause permanent damage to
the coating. Use only chemically inert cleaners (neither acidic nor alkaline), for example. Instanet or Glassex.
Glass must first be wiped from both sides carefully with a damp cloth (or a soft sponge) to collect all the dirt and then
wipe it with a dry Microfiber cloth that came with your device. Always thoroughly dry the glass as formed on the
surface stains can irreversibly melt into the glass. In the case of larger dirt, for pre cleaning of the glass, you can use
liquid for cleaning ceramic hobs or window glasses. But always at the end of the glass cleaning process, make sure you
wipe it dry (after washing off the cleaning liquid with clean water) with a microfiber cloth attached to the device. If
the glass is transferred by means of vacuum suction, keep in mind that the rubber suction cup must be clean and dry
to avoid damaging the anti-reflective coating. If visible traces of the suction cup will remain on the glass, they should
be removed.
