Planex RX-35U, Руководство пользователя

Страница: 13 / 22

16 15
10. When the Wizard finishes installing the devices, open the My Computer
folder and see whether a new drive named "Local Disk" has been added.
(In the example below, this drive is treated as "E:" drive.)
Once the driver has been installed and the HDD is enabled, the HDD (and
thus the HDD case) is ready for use at the moment you re-connect the HDD
case to the USB port of your PC / USB hub: there is no need to go over the
installation steps again. Driver installation is now complete.
(Warning)
DO NOT remove the USB cable from the USB port or turn off the power
switch while the HDD is being accessed. Doing so may result in serious
damage to the HDD. If you are not certain about the status of the HDD,
turn off the power switch and remove the cable.
* If you are using a new HDD (that has not been used before), proceed to "Chapter 5: Using
a New Hard Disk Drive".
1. Set the supplied installer FD to your floppy
drive.
2. Locate the Task Bar of the desktop, and click on
the Start button. Then select the "R"(Run
files/applications) option by clicking on it.
3. In the "O" (Open) field, enter "A:\SETUP.EXE" and click on the OK
button.
Installing RX-35U3 3 2
RX-35U/RX-35U3 RX-35U/RX-35U3
new-RX-35U7-27 8/3/2000 12:48 PM 頁面 25