10
L350 MECHANICAL INSTALLATION GUIDE
4) Before removing any of the bolts securing
the fork-arm to the base-motor: A) be sure that
the Azimuth/RA locking knob is engaged, and
B) it is helpful to make a reference mark for
later realignment of the two assemblies. Both
are shown in the top-right image.
5) Now the bolts holding the fork-arm to the
base-motor can be removed. There are a to
-
tal of 6, at evenly spaced intervals, around the
upper perimeter of the base-motor. For refer
-
ence, 4 of the 6 are shown in the highlighted
part of the drawing to the middle-right.
Be careful not to bump or jostle the mount
while these bolts are removed. The fork-arm is
still being held in place by two shoulder-bolts,
but can be knocked over if one is careless.
6) Before lifting the fork-arm, it is recommend
-
ed that you place something on the ground,
nearby, onto which the fork can be set without
being scratched. This could be a tarp, old blan
-
ket, sheet of cardboard, or even the front-pan
-
el of your crate.
7) See “lifting points” under the Installation
chapter.
8) Stand on the fork-arm side of the mount,
and slide the fork-arm laterally so that fork-
tine moves closer to the base-motor’s center
of rotation. This is shown in the image to the
bottom-right.
Содержание L-350
