Planeta HD3N-EX, Руководство по эксплуатации и обслуживанию

Страница: 20 / 28

8
PLANETA PLANET PLANET
1861
Heben ohne Grenzen
Installation hint
– Do not use the hoist and trolley without corrosion protection (grease) under free sky
or leave it there.
– If it is necessary that the unit has to be used outside, we recommend to construct
a littel “hut” or only a roof like a “car port” to protect the unit against rain and other
environed aggressive infl uences. A new PLANETA-hoist is not restricted in use
outside or under the described conditions, but during the operations while chains
move and wheels drive, there will be wear on metal parts where corrosion can take
effect. This is not a warrenty claim! Mainly high temperatures, high air moisture,
acid atmospheres, poison steams or high dust polution are the major reasons why
a hoist can get wear and can get a shortened life time. Mechanical moving parts
are mostly affected. Watch these parts generally and keep them greased and
maintained whenever it seemes to be necessary.
– When your unit will be used daily and it is important that it functions absolutely for
sure, please buy a spare unit to have it at hand in case of trouble. This avoids down
time in your production.
– Do not allow the unit and chain to be exposed to extremely cold whether. Do not
apply loads to a cold chain. Temperatures lower -20°C or high60°C may
decrease the safe working load. Call manufacturer if in doubt!
5. Installation
Prior delivery, all units have been lubricated, tested with full load and overload and they
received a test certifi cate.
The distance and carrying bolts of the trolley are equipped outside with distance
sleeves/discs which could be released after displacing of the nuts. Then move the side
plates as far as necessary to the outside that the trolley can be lifted from beneath
over the beam fl ange. Now push the trolley side plates in direction to the beam fl ange
until the wheels fi t correctly the beam fl ange. Tighten the distance sleeves and the nuts
again. See table for torque. If the beam is open at one end, it is easier to roll the trolley
from there directly on the beam. Once the trolley is installed, move it for fi rst test. Hand
chains should hang down proper and freely and should not have any kinks or twists.
After this worked fully satisfying and safe, you can start with the normal operation of
the trolley.