ENG
PLANAR-8DM
13
Attention!
Check the fuel tank before the heating season starts. In case fuel was stored in the tank
for a long time (e.g. from the last heating season),
drain
it. Flush the tank with gasoline or
kerosene and fill with
new diesel fuel
. This is needed to remove deposits that tend to build
up during long storage of the fuel in the tank. Failure to observe this requirement may lead
to
clogging
or
failure of the fuel pump
or increased sooting of the combustion chamber.
Scope of supply of a PLANAR-9D-24 heater includes the fuel pump that must be
installed in the position shown on Fig. 8.4а, i.e. ± 5
˚
from the horizontal level.
Fig. 8.4а Allowable position for installation of the fuel pump
8.4.2 Fuel supply from the vehicle tank through the fuel intake pipe (optional)
The fuel intake is installed into the fuel tank as shown on Fig. 8.5
а) Install the special washer with the fuel intake in the tank opening
as shown on Fig. 8.5.
b) Install the fuel pipe between the fuel intake and the heater
as shown on Fig. 8.6.
Attention!
Observe safety requirements for working with vessels used for storage of
combustible/explosive fuel while cutting the opening in the fuel tank.
Intake
Outlet