Pixsys PL260, Руководство пользователя

Страница: 24 / 72

24
Bit 10 If set to ON this bit enables mode “modem” for
serial port EXP1. This means that Timeout
between one character and the other
character in receiving mode is automatically
set to 40mS.
R/W
Bit 11 If set to ON this bit enables mode “modem” for
serial port COM2. This means that Timeout
between one character and the other
character in receiving mode is automatically
set to 40mS.
R/W
Bit 12 If set to 1, this bit disables internal clock
reading/writing, making faster program
execution.
R/W
Bit 13 If set to 1, this bit disables counters C[1..16]
and enables timers T[49..64], normally
disabled.
R/W
SM1 1001 Diagnostic Bit (faults/anomalies)
Bit 0 This bit is ON if the retaining data of the area
“special marker” are lost. R/W
Bit 1 This bit is ON if the retaining data of the
“marker” area are lost. R/W
Bit 2 This bit is ON if the retaining data of EEProm
area are lost. R/W
Bit 3
This bit is ON if calibration data are lost.
R/W
Bit 4 This bit is ON if the CPU has been reset or if
there is a watchdog intervention. R/W
Bit 5 This bit is ON if there is stack overflow on the
ram reserved area. R/W
Bit 6
This bit is ON if an error has occurred during
the calibration process. R/W
Bit 7 This bit is ON if there is an error/fault of serial
EEprom. R/W
Bit 8 This bit is ON if there is an error/fault of serial
clock. R/W
Bit 9 This bit is ON if there is an error/fault of the 16
bit digital analogue converter. R/W
Bit 10 This bit is ON if there is a stack overflow of
timed interrupts.
R/W