6
Press
START
Press
UP
DOWN
Press
UP
DOWN
Key ON.
(Engine Start)
ECO Mode
SPORTS Mode
NORMAL Mode
MODE
1
2
Smallest Change
Ratio (-10%)
Greatest Change
Ratio (-50%)
(−30%)
(−40%)
Greatest Change
Ratio (+70%)
Smallest Change
Ratio (+10%)
(+30%)
(+20%)
【
Reference 4
】
Basic Control Features
Ec5
Ec5
Ec5
SP7
SP7
SP7
100
50
0
50
100
Amount of pressure placed on the accelerator pedal (%)
RESPONSE
FUEL
EFFICIENCY
SPORTS
NORMAL
ECO
Good
Mode
7
6
5
4
3
2
1
1
2
3
4
5
Good
Bad
Bad
ROAD GRIP
(during acceleration)
Slippery
Not Slippery
How to Operate
After completing operations do not turn the key OFF for at least
2 seconds. The settings will not be saved.
Switching Response Levels
Make settings for response in each Mode.
Switching the Mode
Switch between 3 modes: SPORTS Mode (Higher Response), ECO Mode (Lower Response), and NORMAL
Mode (Standard Response).
The mode will change
with each pressing of
the “MODE” switch.
※
For safety, when changing modes always go through (NORMAL) one time.
About the Relay sound
: When switching to for safety reasons
the relay will go into operation and you will hear a clicking sound.
●
Switching the Change Ratio for ECO Mode
will change with each pressing
of the
▲
(UP) /
▼
(DOWN) switch.
is displayed, the ratio
●
Switching the Change Ratio for SPORTS Mode
will change with each pressing
of the
▲
(UP) /
▼
(DOWN) switch.
is displayed, the ratio
Adjusting the Change Ratio for each Mode
Switch the change ratios within SPORTS Mode (SP) and ECO Mode (Ec).
●
When making adjustments to the change ratios, begin at the lowest setting and slowly make changes while
continually checking acceleration.
●
Saving Settings:
All settings are saved even after the engine has been turned off. However, if the engine is turned off in 2 seconds or
less after the last setting operation was carried out, the settings will not be saved.
For more details about the modes for when restarting the engine see P. 7 “Mode Settings for when Restarting the Engine”.
If while in NORMAL Mode, the SET switch is pressed in for a long time the unit will go to “Initial Settings”, and if in SPORTS Mode the
SET switch is pressed in for a long time, the unit will go to “Mode Settings for when Restarting the Engine”; if this happens stop all
operations and return to the normal display.
Even if the mode is switched the respective change ratio settings will not be changed.
Acceleration output signal based on amount of
pressure placed on accelerator pedal
Acceler
ation Output Signal
(at deg
ree monitor)(%)
※
In ECO Mode, because response is less than the standard fuel efficiency can be improved.
However, if rapid acceleration is purposefully carried out fuel efficiency will be reduced.
※
The changes in response will be greater as the vehicle’ s power is greater.
【
Reference 3
】
Examples of changes in fuel consumption and response
depending on change ratios
The changes throughout each Mode will be controlled
smoothly without perceptible steps.
F
eatures
Connecting
The Wires
Installing
The Pr
oduct
Ho
w to
Operate
Bef
o
re
Using
T
roub
le-
Shooting
Initial
Settings
Installing The Product
procedure
3
Affix with double-sided tape to
a position which is easy to
see and which allows for easy
operation.
Main Unit
(How to Install)
(Example of Installation)
Double-sided
tape (Included)
Clean to remove
oil and dust.
Center console
On the steering
column cover
Under Cover
Please be sure to bundle away
all wires with tape not to get
damaged by any steel plate or
screws as this may cause short
circuit.
