3
Connecting The Wires
procedure
1
Bef
o
re
Using
F
eatures
Connecting
The Wires
Installing
The Product
Ho
w to
Oper
ate
T
roub
le-
Shooting
Initial
Settings
Special Model
Specific Harness
Accelerator Connector
Accelerator
OBD2 Connector
2P
Connector
4P
Connector
Basic Wiring
When installing make sure to use the specialized harness (included).
Connect to Power
(
⇒
Page 4)
Main Unit
(Male)
(Female)
Accelerator
Accelerator
Connector
Disconnect
the connector
Turn the key
to OFF
LOCK
（
OFF
）
15
minutes
Important Notice about Removing Accelerator Connector
●
If for some reason the CHECK Lamp does come
on, please see “How to Turn Off the CHECK
Lamp” on Page 8.
●
Using a harness other than the one which is
supplied with this product may cause malfunction
or damage; use only the supplied harness.
Only disconnect the accelerator connector after having waited at least 15 minutes from the time that the key was turned OFF.
Depending on the model of car, removing the connector immediately may cause the CHECK Lamp to come on.
Installing The Specialized Harness
Accelerator
Connector
Accelerator Connector
Accelerator
Pedal
Locked Unlocked
Slide
about
1 cm
Locked
Unlocked
Slide
about
1 cm
Insert until you
hear a “click”
Checking the Accelerator Connector.
While pressing down on the catch as shown in the
diagram below, pull to remove the accelerator
connector.
※
Even if there is no lock remove in the same manner.
Insert the specialized harness (Female end) into
the car side of the accelerator connector.
Insert the disconnected accelerator connector
into the specialized harness (Male end).
※
If there is a lock (Red), after inserting, make sure
to re-lock the unit by sliding the lock back into
the locked position.
If there is lock (Red) on the accelerator connector,
unlock as shown in the figure below.
※
If there is no lock, move to step
3
.
Be careful that the harness is in the
correct direction.
Specialized Harness (Male end)
Accelerator Connector
Insert
Specialized
Harness
(Female end)
Connector of
Accelerator part
1
2
3
4
5
While pressing
this catch disconnect
the connector.
▼
Figure as seen from
the side
Salient
Salient
Salient
※
Press and hold this catch
to disconnect the special-
ized harness.
Long
Short
Lock
(Red)
Lock
(Red)
Lock (Red)
Be careful that the harness
is in the correct direction.
