PITSID NIP CON SMART, Руководство по эксплуатации

Страница: 5 / 22

9 8
DOC_NIP_CON_SMART_EN_20200619 DOC_NIP_CON_SMART_EN_20200619
EN
EN
5 Measuring Principle
To determine the contact strip width (NIP width), sensors are positioned between the
rollers to be measured. By creating pressure in the active sensor area, the width of
the contact zone is detected.
This value depends on the roller diameters, the rubber hardness
and the rubber thickness. By entering these roller parameters, these
influences on the contact strip width is taken into account
6 The Measuring System
6.1 Scope of Delivery
•
Hand-held device
•
2 Sensors
•
USB-cable
•
Carrying case
•
Operation manual
•
Installation software on a USB stick
•
Tablet (10,1“) with protective case
The measuring system was checked before delivery. Please check the
delivery for completeness and transport damage after unpacking. In
the event of damage or missing system components, contact the
supplier or manufacturer.
6.2 Operation and Control Elements, Connections
The measuring system is generally operated with a PC, tablet or smartphone.
Operating and control elements are an essential part of the software.
The necessary functionality on the hand-held device (Figure 1) was
supplemented by information elements.
Fig. 1. Hand-held device
The hand-held device is secured against unintentional start-up with
the slide switch (9) set to OFF during shipping. Set the slide switch to
ON before the initial start-up.
6.3 Sensor
The sensors used are foil potentiometers. The sensors are connected to the jacks
(6) on the hand-held device and measure the nip width in the active sensor area.
( Chapter 7.3.1 Measurement Preparation)
Fig. 2. NIP-Sensor
7 Operation
7.1 Software Installation
The necessary software for the tablet and PC is found on the USB stick. If the tablet is
included in the scope of delivery, the software has already been pre-installed.
1 Attachment ring
2 Optical set point indicators
3 Wireless connection indicator
4 ON/OFF button
5 Charge level indicator
6 Sensor jack
7 USB jack
8 Mounting magnet on the back
(installed inside the housing)
9 Sliding switch for the battery
Active
sensor area