PITSID NIP CON SMART, Руководство по эксплуатации

Страница: 19 / 22

37 36
DOC_NIP_CON_SMART_EN_20200619 DOC_NIP_CON_SMART_EN_20200619
EN
EN
The remaining charge of the handheld device is monitored. The
battery can only be recharged after it has been discharged to 75 %
of the battery capacity (<3.95 V).
▬
The battery should never be completely discharged.
IMPORTANT Deep discharge can destroy the battery.
▬
The temperature of the battery during the charging process should not exceed
5… 40° C.
IMPORTANT
Extreme temperatures can cause damage. Charging capacity and
battery life are reduced.
The temperature of the handheld device is monitored. In the
temperature range (<0° C, >50° C), the handheld device cannot be
switched on or switches off automatically.
▬
During the charging of the hand-held device, the blinking of the respective LED
of the charge status indicator (5) allows monitoring of the charging progress.
When the device is switched off, it may take approx. 20 s until the
charging progress is displayed.
▬
After disconnecting the charging (USB) cable, the LEDs on the charging status
indicator light up.
Display on hand-held device Display in the measured value window Battery level
Green
>83%
>66%
Yellow
>50%
>33%
Salmon red >16%
Red < 16 %
Battery charge level
▬
The hand-held device is in charging mode. It can now be individually switched
ON or OFF.
It switches off automatically after 5 minutes.
The battery level of the measured value display window always
identifies the battery with the lowest remaining charge in the
system (battery level of the measuring system).
▬
Never use a damaged or defective charger (or USB cable) when charging
Warning
Damaged or broken chargers can cause an electric shock!
IMPORTANT Damaged or defective chargers can cause damage to the device.
▬
Removing the battery is not intended for the user.
IMPORTANT Improper opening can damage the device.
If necessary, the manufacturer will replace the battery!
8.2 Cleaning
The measuring system, especially the sensors, should be cleaned when dirty.
Please note:
Warning
The hand-held device is not waterproof and not dustproof
(protection class IP20).
Warning There is danger due to short circuit
IMPORTANT Penetrating liquids can damage the device.
IMPORTANT
The use of unsuitable chemicals or solvents can damage the exterior
and interior of the device. Note the chemical resistance of the
materials.
Coarse contamination of the measuring system should be avoided.
The tablet should always be used with the protective case included
in the scope of delivery.