L20-406 Rev 7 (01/17) Page 27
Display
Meaning
Action.
The Controller is OFF.
Press the I/O key to turn the
controller on.
Fryer is in MELT mode for liquid cooking
medium.
Wait for the appliance to heat up.
Fryer is in MELT mode for solid
shortening.
Wait for the appliance to heat up.
Oil/Shortening temperature is low. Fryer
is heating.
Wait for the appliance to heat oil.
Oil/Shortening is at temperature.
Perform cooking activities as
needed.
The drain valve is open while the
appliance is ON.
Turn the appliance OFF. Close drain
valve before turning appliance back ON.
Element housing is in the ‘UP’ position.
Lower element assembly into oil.
Float switch (if equipped) is in the down
position.
Fill tank with oil/shortening/dislodge the
float switch, if stuck.
Incorrect probe reading/damaged probe. Contact Authorized Service Company.
Oil/Shortening has reached an unsafe
temperature.
Turn off the appliance. Allow time for ap
-
pliance to cool before restarting.
Incorrect probe reading/damaged probe. Contact Authorized Service Company.
Temperature probe is shorted
Contact Authorized Service Company.
Indicates that the oil in the vat is in need
of polishing.
Operators may, depending on settings,
polish now or defer the polish operation
for a later time.
Shows when the number of cooks since
the last filter operation exceeds the Cook
Counts Allowed Value.
Perform a filter operation as soon as
business levels permit.
The JIB is low or empty.
Replace the JIB if it is empty. Refer to the
control manual shipped with your appli
-
ance to clear this message.
Indicates the computer has lost communi
-
cation with the autofilter control board. Oil
management operations are suspended.
Normal cooking activities are unaffected.
Contact Authorized Service Company.
6.6 CONTROLLER DISPLAYS
Below is a list of common computer controller displays and guidance. For additional computer controller displays
and information concerning them, refer to the controller manual that was shipped with your appliance.
TROUBLESHOOTING
