MGII and MG2T GAS FRYER
SERVICE
L22-236 Rev. 2 (06/11)
19
5.2. Control
Components
5.2.1. Ignition Module
1. Using a 5/16” hex bit, remove screw securing
ignition module bracket.
2. Disconnect ignition cable from module. Needle
nose pliers may be needed to accomplish this.
3. Slide module bracket toward you, and then to
the right (or left) away from the cabinet side.
This will disengage the two tabs at the rear of
the bracket allowing removal of the module
and bracket.
4. Disconnect the 6 position electrical connector.
5. Remove the module and bracket from the
fryer.
6. Remove screws securing module to bracket.
7. Remove harness from module.
8. Installation is reverse of removal.
5.2.2. Transformer
Box
1. Using a 5/16” hex bit, remove 4 screws
securing Cabinet Rear Bottom Cover and
remove cover.
2. Unplug Electrical Connectors from the rear of
the Transformer Box.
WARNING! SHUT OFF APPLIANCE AND DISCONNECT ALL POWER
CONNECTIONS PRIOR TO STARTING ANY SERVICE WORK
