Pit Boss 75204, Инструкции и руководство пользователя

Страница: 16 / 28

16
OPERATING INSTRUCTIONS
FIRST USE – PRIMING THE GRILL
When firing your grill for the first time, it is advisable to run the main burner(s) on “HIGH” for 20 minutes with the hood down
and then turn the main burners off. This tempers the grill.
IMPORTANT: Ensure the hood is completely open each time you attempt to light the grill. Failure to open the hood
could lead to delayed ignition resulting in bodily harm. Use the flame observation hole in the side panel.
PREHEATING
It is extremely important that your grill be up to temperature before you begin using it. After lighting, close the hood and preheat
the grill on “HIGH” for 15 minutes. This preheating will ensure that the cooking grid and grate are hot enough for proper grilling.
ELECTRONIC LIGHTING INSTRUCTIONS
To Light the Main Burners and the Side Burner
1. Make sure the control knobs are in the “OFF” position.
2. Open the grill hood.
3. Check the ignition pin position and distance between the pin and the burner.
4. Make sure the drip tray is installed.
5. Open the LP tank or natural gas valve.
6. Light each burner separately. Turning on two burner valves together could trip the flow
limiting device in the tank connection (LP grills only).
7. Push the control knob in and turn the knob to the left to “HIGH” position.
8. Push and turn burner control knob to “HIGH” and immediately press and hold electronic igniter.
9. If the burner still does not ignite, TURN OFF THE GAS. WAIT 5 MINUTES for excess gas to dissipate.
10. If the burner still can’t be lit, refer to the troubleshooting section.
MANUAL LIGHTING INSTRUCTIONS
IMPORTANT: The hood must be open when lighting any burner manually with a match.
1. Turn on gas supply.
a) If portable, at the LP cylinder valve.
b) If permanent gas supply, at the manual gas shutoff valve.
2. Locate the flame observation holes on each side.
3. Open the right door to access the match clip with chain.
4. Attach either the match or paper to the clip), light the
match and insert it close to the ports of the burner, and
push and turn the depressed knob to the
left to “HIGH” position.
5. The center burner (if needed) can be lit from center grid by
inserting the match clip into the front side of flame tamer.
Light this burner before igniting both outside burners.
6. Depress burner valve for that burner and turn to “HIGH.”