PIPER AIRCRAFT CORPORATION
SECTION 8
PA-28-161 WARRIOR III
HANDLING, SERV & MAINT
PIPER AIRCRAFT CORPORATION
SECTION 8
PA-28-161 WARRIOR III
HANDLING, SERV & MAINT
ISSUED: JULY 1, 1994
REPORT: VB-1565
8-7
ISSUED: JULY 1, 1994
REPORT: VB-1565
8-7
(5) Secure tie-down ropes to the wing tie-down rings and to the
tail skid at approximately 45-degree angles to the ground.
When using rope of non-synthetic material, leave sufficient
slack to avoid damage to the airplane should the ropes
contract.
CAUTION
Use bowline knots, square knots or locked slip
knots. Do not use plain slip knots.
NOTE
Additional preparations for high winds include
using tie-down ropes from the landing gear forks
and securing the rudder.
(6) Install a pitot head cover if available. Be sure to remove the
pitot head cover before flight.
(7) Cabin and baggage doors should be locked when the
airplane is unattended.
8.11 ENGINE AIR FILTER
The wet-type polyurethane foam air filter must be inspected at least once
every fifty hours. Under extremely adverse operating conditions, it may be
necessary to inspect the filter more frequently. The filter is disposable and
inexpensive and a spare should be kept on hand for a rapid replacement.
(a) Removal Of Engine Air Filter
The filter is located in the lower right front of the engine
compartment and may be removed by the following procedure:
(1) Open the right side of the engine cowling.
(2) Loosen each of the four quarter-turn fasteners securing the
air filter cover.
(3) Separate the cover and remove the filter.
(4) Inspect the filter. If it is excessively dirty or shows any
damage, replace it immediately.
(5) Secure tie-down ropes to the wing tie-down rings and to the
tail skid at approximately 45-degree angles to the ground.
When using rope of non-synthetic material, leave sufficient
slack to avoid damage to the airplane should the ropes
contract.
CAUTION
Use bowline knots, square knots or locked slip
knots. Do not use plain slip knots.
NOTE
Additional preparations for high winds include
using tie-down ropes from the landing gear forks
and securing the rudder.
(6) Install a pitot head cover if available. Be sure to remove the
pitot head cover before flight.
(7) Cabin and baggage doors should be locked when the
airplane is unattended.
8.11 ENGINE AIR FILTER
The wet-type polyurethane foam air filter must be inspected at least once
every fifty hours. Under extremely adverse operating conditions, it may be
necessary to inspect the filter more frequently. The filter is disposable and
inexpensive and a spare should be kept on hand for a rapid replacement.
(a) Removal Of Engine Air Filter
The filter is located in the lower right front of the engine
compartment and may be removed by the following procedure:
(1) Open the right side of the engine cowling.
(2) Loosen each of the four quarter-turn fasteners securing the
air filter cover.
(3) Separate the cover and remove the filter.
(4) Inspect the filter. If it is excessively dirty or shows any
damage, replace it immediately.
Содержание WARRIOR III PA-28-161
