Advanced Setup | Firmware Update | Others
Audio Adjust
■
Dual Mono/Mono
■
Dolby
■
Volume
Source
■
Input Volume Absorber
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
■
Name Edit
Set an easy name to each input. The set name will be shown on the main unit display. Select
the input selector to configure.
0
To name a preset radio station, press TUNER on the remote controller, select FM/DAB
and select the preset number.
0
This cannot be set if the "NET","USB" or "BT AUDIO" input is selected.
46
Input Volume Absorber Select a value between "
–
12 dB" and "
+
12 dB". Set a negative
value if the volume of the target device is larger than the others
and a positive value if smaller. To check the audio, start playback
of the connected device. (Default Value is "0 dB")
Name Edit
1. Select a character or symbol with the cursors and press
ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower cases. (Pressing
MODE on the remote controller also toggles between upper
and lower cases)
" " " ": Moves the cursor to the arrow direction.
"
": Removes a character on the left of the cursor.
" ": Enters a space.
0
Pressing CLEAR on the remote controller will remove all
the input characters.
2. After inputting, select "OK" with the cursors and press
ENTER.
The input name will be saved.
E
N
Loudness
Management
When playing Dolby TrueHD, enable the dialog normalization
function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when playing Dolby
Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
Dual Mono
Set the audio channel or language to be output when playing
multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0
If multiplex audio is being played, "1+1" will be displayed on
the display of this unit when
on the remote controller is
pressed.
Mono Input Channel
Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
Volume Limit
Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
Headphone Level
Adjust the output level of the headphones. Select a value
between "-12 dB" and "+12 dB". (Default Value is "0 dB")
