Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
!
No audio is outputted if the center speaker
setting is
SMALL
or
LARGE
and no center
speaker is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL
or
LARGE
.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1
Touch NEXT on the DSP function menu.
2
Touch SPEAKER LEVEL.
3
Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
FRONT L
(front speaker left)
—
CENTER
(center
speaker)
—
FRONT R
(front speaker right)
—
REAR R
(rear speaker right)
—
REAR L
(rear
speaker left)
—
SUB WOOFER
(subwoofer)
#
You cannot select speakers whose size is set
at
OFF
. (Refer to
Setting the speaker setting
on
the previous page.)
4
Touch
c
or
d
to adjust the speaker out-
put level.
Each time you touch
c
or
d
increases or de-
creases the speaker output level.
+10
to
–
10
is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE
. Both provide the same results.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SMALL
, you can select a
frequency, under which sounds are repro-
duced through a
LARGE
speaker or subwoo-
fer.
1
Touch NEXT on the DSP function menu.
2
Touch CROSS OVER.
3
Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
FRONT
(front speakers)
—
CENTER
(center
speaker)
—
REAR
(rear speakers)
—
SUB WOOFER
(subwoofer)
4
Touch
c
or
d
to select cross-over fre-
quency.
Each time you touch
c
or
d
selects cross-over
frequencies in the following order:
63Hz
—
80Hz
—
100Hz
—
125Hz
—
160Hz
—
200Hz
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’
s L.P.F. (low-pass
filter) and that of the
SMALL
speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF
and other
speakers are set to
LARGE
or
OFF
.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1
Touch NEXT on the DSP function menu.
2
Touch TEST TONE.
Available accessories
En
75
Section
04
A
vailable
accessories
