Pioneer DVR-440HX-S, Инструкция по эксплуатации и руководство пользователя

Страница: 141 / 172

The Initial Setup menu 16
141
En
Channel Swapping Next Screen
Proceed to the next screen to swap channel
assignments of different presets so that you can
group together presets that naturally go together.
Select two presets to swap then press
ENTER
.
Video In/Out
Input Colour
System Next Screen
Proceed to the next screen to set the input colour
system for the external input and the built-in TV
tuner. Use the
Smart Jog
(DVR-940HX-S) or
PREV/
NEXT (DVR-545HX-S) or INPUT SELECT
buttons to change the preset or external input. On
the default
Auto setting the recorder can generally
correctly detect whether the input signal is PAL,
SECAM, 3.58 NTSC or PAL-60, but in some cases you
may have to set it manually if the picture is displayed
incorrectly.
• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 151 for more information on this setting.
Component Video
Out Interlace •
Select if your monitor/TV is not compatible with
progressive-scan video.
Progressive
Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you’re not sure.
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than
RGB
.
If your TV is incompatible with progressive scan video and you select Progressive , you will not be able to see any
picture at all
. In this case, press ONE TOUCH COPY while holding down the ( STOP ) button on the front
panel to switch to
Interlace
(this also switches Screen Resolution
on page 148
to the default setting).
When an HDMI device is connected and Video Priority Mode is set to
HDMI
, the Component Video Out setting
is automatically set to Interlace .
AV1 Out Video • Sets the AV1(RGB)-TV SCART output to standard
composite video (compatible with all TVs).
S-Video Sets the AV1(RGB)-TV SCART output to S-video.
Recommended if you are using a long SCART cable.
RGB
Sets the
AV1(RGB)-TV
SCART output to RGB. Good
quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 167).
The Component Video Out setting (see above) has no effect when AV1 Out is set to
RGB .
Setting Options Explanation
DVR940HX_UK_EN.book 141 ページ ２００６年７月１２日 水曜日 午後４時５分