Operating the DSP details menu
1
DSP display
Shows the DSP status.
2
PL II indicator
Shows when the Dolby Pro Logic II is turned
on.
%
Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
display the DSP function names.
After
AT EQ
is displayed, press
AUDIO
repeat-
edly, the following DSP functions appear in
the display:
AT EQ
(auto-equalizer on/off)
—
FRONT
(speak-
er setting)
—
HPF
(cross-over frequency)
—
FRT-L
(speaker output level)
—
TEST TONE
(test
tone)
—
TA
(time alignment mode)
—
FL
(time
alignment adjustment)
—
PEQ-2
(3-band para-
metric equalizer)
#
You can also use
A.MENU
button on the re-
mote control to select an audio menu.
#
When you select
TA OFF
in
TA INITIAL
, you
cannot select
FL
.
#
You cannot select
AT EQ
if auto TA and EQ
has not been carried out.
#
To return to the display of each source, press
BAND
.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to
Auto TA and
EQ (auto-time alignment and auto-equalizing)
on this page).
You can turn the auto-equalizer on or off.
1
Press AUDIO and hold until AT EQ ap-
pears in the display.
#
If auto TA and EQ have not been carried out,
SET A.EQ
is displayed when
AT EQ
is selected.
2
Press
a
to turn the auto-equalizer on.
AT EQ ON
appears in the display.
#
To turn auto-equalizer off, press
b
.
Auto TA and EQ (auto-time
alignment and auto-equalizing)
The auto-time alignment is automatically ad-
justed for the distance between each speaker
and the listening position.
The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.
WARNING
To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.
CAUTION
!
Carrying out auto TA and EQ under the follow-
ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
—
When speakers are incorrectly connected.
(e.g., When a rear speaker is connected to
a subwoofer output.)
—
When a speaker is connected to a power
amp delivering output higher than the
speaker
’
s maximum input power capabil-
ity.
Available accessories
En
73
Section
04
A
vailable
accessories