Pioneer CDJ-2000NXS, Руководство по обслуживанию

Страница: 2 / 158

2
CDJ-2000NXS
1 2 3 4
A
B
C
D
E
F
1 2 3 4
SAFETY INFORMATION
WARNING
This product may contain a chemical known to the State of California to cause cancer, or birth defects or other reproductive
harm.
Health & Safety Code Section 25249.6 - Proposition 65
This service manual is intended for q ualified service technicians; it is not meant for the casual do-it-
yourselfer. Qualified technicians have the necessary test e q uipment and tools, and have been trained
to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not
q ualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a q ualified service technician.
This product contains mercury. Disposal of this material may be regulated due to environmental
considerations. For disposal or recycling information, please contact your local authorities or the
Electronics Industries Alliance: www.eiae.org.
The backlighting lamp of LCD in this equipment contains mercury. Disposal of this material may be
regulated due to environmental considerations according to Local, State or Federal Laws.
For disposal or recycling information, please contact your local authorities or the Electronics Industries
Alliance: www.eiae.org
IMPORTANT
T H I S P I O N E E R A P PA R AT U S C O N TA I N S
LASER OF CLASS 1.
SER
V ICI N G OPERATIO N OF THE APPARATUS
S H O U L D B E D O N E B Y A S P E C I A L LY
I N STRUCTED PERSO N .
Additional Laser Caution
1. Laser Interlock Mechanism
The position of the switch (S9002) for detecting loading
completion is detected by the system microprocessor, and the
design prevents laser diode oscillation when the switch is not in
LPS1 terminal side (when the mechanism is not clamped and
LPS1 signal is high level.)
Thus, the interlock will no longer function if the switch is
deliberately set to LPS1 terminal side.
( if LPS1 signal is low level ).
In the test mode
∗
the interlock mechanism will not function.
Laser diode oscillation will continue, if pin 5 (pin 3) of
A
N 22022A (IC7002) on the SR V B Assy is connected to G N D,
or else the terminals of Q7002 (Q7001) are shorted to each
other (fault condition).
2. When the cover is opened, close viewing of the objective lens
with the naked eye will cause exposure to a Class 1 laser beam.
For D V D Wave length (typ) : 655 nm
Operation output : 3 mW CW, Class 1
Maximum output : Class 1 (Under fault condition)
For CD Wave length (typ) : 790 nm
Operation output : 4.5 mW CW, Class 1
Maximum output : Class 1 (Under fault condition)
Laser Pickup specifications and Laser characteristics
LABEL CHECK
Bottom view
for UXJCB and FLXJ
(Printed on the plate)
for SYXJ 8 , AXJ5 and KXJ5
(Printed on the plate)