Before installing this
product
!
This product is for vehicles with a 12-volt
battery and negative grounding. Check the
battery voltage of your vehicle before instal-
lation.
!
To avoid shorts in the electrical system, be
sure to disconnect the (
–
) battery cable be-
fore beginning installation.
To prevent damage
WARNING
!
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on the
fuse holder.
—
When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
—
This product cannot be installed in a vehi-
cle that does not have an ACC (accessory)
position on the ignition switch.
ACC ON
S
TA
RT
O
FF
ON
S
TA
RT
O
FF
ACC position
No ACC position
!
When the
“
Antenna Control
”
mode is set
to
“
Radio
”
, the vehicle
’
s antenna can be
stowed or turned off by following the in-
structions below.
—
Change the source from radio (AM or
FM) to another source
—
Turn the source off
—
Turn off the ignition switch (ACC OFF)
!
If the
“
Antenna Control
”
mode is set to
“
Power
”
, the vehicle
’
s antenna can be
stowed or turned off only when the ignition
switch is turned off (ACC OFF).
!
To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
!
Attach the connectors of the same color to
the corresponding colored port, i.e., blue
connector to the blue port, black to black,
etc.
!
Refer to the owner
’
s manual for details on
connecting the power amp and other units,
then make connections accordingly.
!
Since a unique BPTL circuit is employed,
do not directly ground the
*
side of the
speaker lead or connect the
*
sides of the
speaker leads together. Be sure to connect
the
*
side of the speaker lead to the
*
side of the speaker lead on this navigation
system.
!
If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
!
Never connect speakers with an output rat-
ing of less than 50 W channel or impe-
dance outside of the 4 ohms to 8 ohms
specifications to your navigation system.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Connecting the System
En
6
Section
03
