DIN Front/Rear-mount
The display unit can be properly installed
either from
“
Front
”
(conventional DIN Front-
mount) or
“
Rear
”
(DIN Rearmount installation,
using threaded screw holes at the sides of unit
chassis). For details, refer to the following illu-
strated installation methods.
Before installing the unit
%
Remove the frame and the holder.
Extend top and bottom of the frame outwards
to remove the frame. And then loosen the
screws (2 mm × 3 mm) to remove the holder.
!
When reattaching the frame, push the
frame onto the unit until it clicks after reat-
taching the holder.
Frame
Screw (2 mm
3 mm)
Holder
DIN Front-mount
Installation with the rubber bush
1
Decide the position of the side brack-
ets.
#
When installing in a shallow space, change
the position of side brackets (small). In this case,
stick conceal tape on parts that protrude from the
dashboard. (The frame is not used.)
Side bracket (small)
Conceal tape
Screw for fixing the side bracket (5 mm
6 mm)
#
If you prefer an off-set installation in which the
front panel is pushed further back, when there is
a space available at the back of the unit, use the
side brackets (large).
Side bracket (large)
Screw for fixing the side bracket (5 mm
6 mm)
2
Install the unit into the dashboard.
After inserting the holder into the dashboard,
select the appropriate tabs according to the
thickness of the dashboard material and bend
them. (Install as firmly as possible using the
top and bottom tabs. To secure, bend the tabs
90 degrees.)
Installation
En
26
Section
04
