58
Installation on the steering
column
1 Detach the microphone base from the micro-
phone clip by sliding the microphone base
while pressing the tab.
4
1
2
3
1
Microphone
2
Tab
3
Microphone base
4
Microphone clip
2 Mount the microphone on the steering column.
2
1
1
Double-sided tape
Install the microphone on the steering column, keeping it
away from the steering wheel.
2
Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Places close to a heater, vent or air conditioner.
Places exposed to direct sunlight, such as on top of the
dashboard.
Places that may be exposed to rain, such as close to the door
or on the vehicle’s floor.
Install this product horizontally on a surface within 0 to
30 degrees tolerance (within 5 degrees to the left or right).
Improper installation of the product with the surface tilted
more than these tolerances increases the potential for errors
in the vehicle’s location display, and might otherwise cause
reduced display performance.
30°
When installing, to ensure proper heat dispersal when using
this product, make sure you leave ample space behind the
rear panel and wrap any loose cables so they are not block-
ing the vents.
Leave ample
space
5 cm
5 cm
Installation using the screw
holes on the side of this
product
1 Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes are aligned with
the screw holes of the bracket, and tighten the screws at three
locations on each side.
1
3
5
2
4
1
Factory radio-mounting bracket
2
If the pawl interferes with installation, you may bend it down
out of the way.
3
Dashboard or console
4
Frame
In some types of vehicles, discrepancy may occur between
the unit and the dashboard. If this happens, use the supplied
frame to fill the gap.
5
Truss head screw
Be sure to use the screws supplied with this product.
Installing the microphone
Install the microphone in a place where its direction and dis-
tance from the driver make it easiest to pick up the driver’s
voice.
Be sure to turn off (ACC OFF) the product before connecting
the microphone.
Depending on the vehicle model, the microphone cable
length may be too short when you mount the microphone on
the sun visor. In such cases, install the microphone on the
steering column.
Mounting on the sun visor
1 Fit the microphone lead into the groove.
1
2
1
Microphone lead
2
Groove
2 Attach the microphone clip to the sun visor.
1
2
1
Microphone clip
2
Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Install the microphone on the sun visor when it is in the up
position. It cannot recognise the driver’s voice if the sun visor is
in the down position.
58
< CRD4941-A >
< CRD4941-A >
Installation
Installation
