Pinnacle Systems Deko1000, Техническое руководство и инструкция по обслуживанию

Страница: 48 / 102

Chapter 5: System Maintenance
48
Deko1000 & Deko550 Technical Reference And Service Guide
Figure 5-5: REF 1 internal cable connected to TARGA card
14. Attach the internal BNC I/O Connection Plate cables to the TARGA card.
When attaching the internal BNC cables from the I/O Connection Plate to the TARGA
card, make sure to match the cable labels on the I/O Connection plate to the labels on the
TARGA card’s bracket for each internal BNC cable. Refer to Figure 5-3. The connections
should be made as follows:
• REF 1 to TARGA REF)
• VIDEO IN to TARGA IN A
• VIDEO OUT to TARGA OUT A
• KEY IN to TARGA IN B
• KEY OUT to TARGA OUT B
Note: All REF BNC’s are the same.
15. Attach the BNC I/O Connection Plate and connect the external BNC cables to it.
Push the I/O Connection Plate back into place on the computer’s frame, and tighten the
two spring screws on the plate to fasten it into place. Then connect all of the external BNC
cables to the front of the BNC I/O Connection Plate.
16. Attach the Fan Cover and Workstation Support Brace.
Place the Fan Cover on top of the fan housing and screw the cover back into place with the
three cover screws previously removed. Put the Workstation Support Brace back in place
just above the TARGA card(s) and other cards. Refer to Figure 5-1. Screw the brace into
place at both ends with its previously removed screws.
17. Attach all other cables and power up the computer.
Connect power cord, monitor cable, and any other communication cables that you
removed previously, and then power up the computer.