Pinnacle Systems Deko1000, Техническое руководство и инструкция по обслуживанию

Страница: 21 / 102

Chapter 3: Installation And Setup
Deko1000 & Deko550 Technical Reference And Service Guide
21
Figure 3-4: Inflexion Diagnostic Utility
Use the pull-down selection box on the upper left-hand side of the Inflexion I/O Diagnostic
window to select the channel to be tested. If you are facing the back panel of the workstation
and looking at the BNCs, then TARGA Board 1 would be the row of BNC’s on the far left.
Then click the “Start Full Test” button on the Inflexion I/O Diagnostic window to run the
automatic mode of the test. If nothing fails on the test, the channel tested is fine.
Note: For three channel workstations only, board 1 will be the row of BNCís on the far left, board
3 will be the middle set , and board 2 will be the row on the far right.
A more detailed explanation of the Inflexion Diagnostic Utility program can be found in
“Chapter 4: Troubleshooting” of this manual.
9. If the workstation is to be rack mounted or moved to another location, disconnect all of
the components and rack mount the workstation chassis.
Each Deko1000 and Deko550 workstation chassis is designed so that industry standard rails
can be connected for rack mounting purposes. Each workstation will fit on 19-inch standard
instrument racks.
10. Make any other connections to the workstation that are necessary for the working
environment.
Other connections would include Genlock Reference, Video Input/Output BNCs, network
cable, etc.
Note: The Audio connections (Speakers, Mic) on the back of the Deko1000 and Deko550 chassis (refer to
Figure 3-2) are disabled at the factory and should not be used.
Repacking A Deko1000 Or Deko550 Workstation
When repacking your Deko1000 or Deko550 system for shipment, please be sure to first remove
the System and Media drives and properly pack them with the system. This will protect the drives
from damage during shipment.