User manual RXN-406 Keypad for CAPTAIN-i Alarm System
6
LED Description
Follow the drawing below, and the successive table.
Zone Status:
The six red lights in the
display area of the keypad
provide the zone status
information for the six
corresponding numbered
zones, as follows:
Off:
Zone is closed.
On:
An alarm was
triggered while the
system was previously
armed, and this event
has been stored in
memory.
Blinking:
Zone is open.
Status & Faults Indicator:
When there is a Fault in the
system, each light
corresponds to a particular
system status or fault (see
table below).
Armed Indicator:
The green
ARMED
light
provides the system Arm
status as follows:
Off:
System is
disarmed.
Blinks once every
four seconds:
Partition #1 armed
Blinks twice every
four seconds:
Partition #2 armed
Blinking:
System is in
Entry or Exit Delay
Time.
Lit constantly:
Entire
system armed (both
partitions)
System Fault LED:
The red
FAULT
light
blinks when a fault is
detected.
RX-406
1
2
3
4
5
6
MEMO
BYPASS
MAINS
BATT
TEL
Status and Faults Indicator:
When a fault or system status change
occurs, a corresponding Status/Fault LED is turned ON, as follows:
Status/Fault
LED
Description
MEMO
Indicates an alarm in one of the zones during the last
system ARM period; To view which zone was alarmed,
press and hold
key until the corresponding
alarmed zone LED is turned ON.
BYPASS
Indicates that one or more of the zones have been
bypassed To view which zone/s were bypassed, hold
and press
key until the corresponding bypassed
zone LED is turned ON.
MAINS
Indicates a failure in the Mains power supply (AC fail).
BATT
Indicates a failure in the battery & low voltage.
TEL
Indicates line failure or communication fault.
