User manual RXN-406 Keypad for CAPTAIN-i Alarm System
5
♦
Monitoring Station Communicator: built-in dialer, integrated
Long-Range Radio and Cellular Transmitters
♦
Inhibit system from arming in case of failure (optional)
♦
Short-keys for DURESS and FIRE codes
Access and Operation Codes
The following codes are used to access and operate the CAPTAIN-
i
Alarm System:
♦
Master Code:
Use this code when programming system
parameters. The default factory Master Code is 5555. For
security reasons, it is not recommended to use the default
code to arm or disarm the system.
IMPORTANT!
For better protection, the default factory
Master Code
must be
changed.
♦
User Code:
4-6 digit code. Up to eight User Codes can
be programmed, User Code 1 to User Code 8.
♦
Short Code:
A convenient, two-digit code used only to
arm the system.
♦
Duress Code:
4-6 digit code used for disarming the
system:
If the system is armed, the code will disarm the system and
send a duress event to the MS
If the system is disarmed, the code will send a silent duress
event to the MS
The RX/N-406 keypad features 6 zone
LEDs and 7 information LEDs as
described in the following drawing
and table (next page). These LEDs
provide zone status information, as
well as system status & fault
information.
