OPERATING MANUAL
PSEN op2H-A series
4 ELECTRICAL CONNECTIONS
18-pin rectangular pigtail cables are used at the light curtain for electrical connections. The
pigtail cable has M12 connectors with a different number of pins on the opposite side.
On muting models, the receiver is equipped with one 12-pin M12 connector and one 5-pin
M12 connector.
After removing the cap shown in grey (see Fig.) the cables must be connected at the bottom
of the light curtain (the end with LEDs and buttons).
Make sure that the terminator cap (see Chapter 13) is connected on the top of the light
curtain. If this connection is missing, the Master and Slave units will switch to a critical
communication state.
PSENopt Advanced RX Muting
18 pin
M12 12 pin
M12 5 pin
M12 12-Pin:
1. 24 V (brown)
2. 0 V (blue)
3. RESET/RESTART/ALIGN (white)
4. OVERRIDE1 (green)
5. OSSD2 (pink)
6. EDM (yellow)
7. MUTING DEACTIVATION (black)
8. OSSD1 (grey)
9. OVERRIDE2 (red)
10. MUTING LAMP (purple)
11. OVERRIDE STATUS (grey-pink)
12.
EARTHING (red-blue)
M12 5-Pin:
1.
24 V (brown)
2.
MUTING2 (white)
3.
0 V (blue)
4.
MUTING1 (black)
5.
NC (grey)
PSENopt Advanced TX
18 pin
M12 5 pin
M12 5-Pin:
1.
24 V (brown)
2.
TEST (white)
3.
0 V (blue)
4.
EARTH (black)
5.
REDUCED RANGE (grey)
1003069-EN-03
25
