PSEN cs5.13 M12/8 EX
Operating Manual PSEN cs5.13 M12/8 EX
22218-EN-04
| 8
Warranty and liability
All claims to warranty and liability will be rendered invalid if
}
The product was used contrary to the purpose for which it is intended,
}
Damage can be attributed to not having followed the guidelines in the manual,
}
Operating personnel are not suitably qualified,
}
Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
Disposal
}
In safety-related applications, please comply with the mission time T
M
in the safety-related
characteristic data.
}
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
For your safety
WARNING!
Loss of safety function due to manipulation of the interlocking device
Manipulation of the interlocking device may lead to serious injury and death.
– You should prevent any possibility of the interlocking device being
manipulated through the use of a spare actuator.
– Keep the substitute actuator in a safe place and protect it from unau-
thorised access.
– If spare actuators are used, these must be installed as described in
.
– If the original actuators are replaced with substitute actuators, the ori-
ginal actuators must be destroyed before disposal.
}
Do not remove the connector's protective cap until you are just about to connect the unit.
This will prevent potential contamination.
}
The connector should be protected from accidental loosening (e.g. using a cable tie).
WARNING!
Ignition spark from cable separator/connector within the potentially
explosive area can trigger an explosion
When the cable separators/connectors are used within the potentially ex-
plosive area, sparks can be caused and lead to an explosion.
– Make sure that the cable separators/connectors are used only within
the potentially explosive area.
}
The IP protection type (see
) has been determined in accord-
ance with DIN EN 60529 with a safety switch that is as new.
