Commissioning
Operating Manual PNOZ s50
1002194EN02
33
NOTICE
Please note that all parameters are set to their default values on delivery.
Please check all the safetyrelated parameters at least, and enter the values
that correspond to your application.
6.2.3
Password protection
The configuration is passwordprotected.
}
Parameters can only be changed once a password has been entered.
}
Factory setting for the password: 000000
}
The pasword consists of 6 figures in the range 000000 … 999999.
}
The password can be changed at any time in the menu.
INFORMATION
– Please note: Remember the assigned password. Without this pass
word you will not be able to change the configuration.
– For details of how to enter the password, see the section entitled
"Status display and configuration", Level 2: Entering the password.
– For details of how to change the password, see the section entitled
"Status display and configuration", Level 3: Configuration.
6.2.4
Use chip card
The parameters that are set on a device are stored on the chip card. The data is stored
along with a device identifier and check sum. We recommend that you always operate the
device with a chip card.
When the chip card is inside the device:
}
The chip card is checked to verify the device identifier, valid parameters, and ensure
that the data is identical.
}
Device parameters are automatically saved to the chip card during configuration. As a
result, the chip card always contains a copy of the device's current internal data.
When the device is switched on in the
Power On
operating state (all LEDs illuminate
briefly) a test is carried out to check whether
}
a chip card is inserted or just an empty chip card holder
}
data on the chip card matches the data in the device
}
data on the chip card is valid.
