39 |
P a g e
Engineering Value (min):
The lowest possible value that the sensor can read, please refer
to the transmitter manufacturer specification.
Engineering Value (max):
The highest possible value that the sensor can read, please
refer to the transmitter manufacturer specification.
Hysteresis:
Set the minimal change required to revert from Critical High / High / Low /
Critical Low alarm state.
Offset Value:
Used to calibrate the raw value signal from the transmitter. You can add or
subtract constant value to the raw value and FMGuard will show you the computed
value on the dashboard.
Set Points:
FMGuard has 4 setpoints for the analog input,
Critical Low, Low, High and
Critical High.
Each setpoints are set to notify the users every time the signal passes or
lowers the setpoints.
Note:
Set the Hysteresis to prevent the transmitter from flickering between two states.
WARNING!!!
If the user input any values that are out of range, FMGuard will not allow the user to save any
configuration. The user must re-enter the correct values to avoid this.
