PIAGGIO VESPA RALLY 200, Эксплуатация и обслуживание

Страница: 23 / 35

OPERATING AND MAINTENANCE: Common operations to carry out
Operation Instructions
SETTING THE HEADLAMP
The correct setting of the main beam can be
obtained both horizontally and vertically as follows:
Check that both front and rear tires are inflated to
correct pressure: i. e. 1.2 and 2.5 Kg/cm2 (15.5 and
35.5 p.s.i.). Place the scooter on a level floor in front
of a white wall as seen in Fig. 19. Start the engine,
hold the throttle control twist grip at about 1 /3 and
set the switch on < main beam >. With two persons
on the Vespa, slacken the screws securing the
headlamp, then move the latter as required, in order
that the beam axis coincides with point <+> on the
wall. Tighten the screws firmly.
NOTES
Do not wipe down with a cloth or contact with finger the reflector. This operation can be
carried out also with the driver only sitting on the machine. In this case, of course, the
beam alignement should be altered whenever the scooter is beeing riden by both driver
and passenger.
Fig. 19 - Setting the headlamp
N. B. - The point <+> is valid for setting with one or two persons mounted.
Note: m. 5=16 FT approx.: m. 0.95 / 0.97 = 3 FT approx.