5 Installation
L-220 Linear Actuator
MP149E
Version: 1.3
17
Tools and accessories
Supplied tip
Optional:
−
Open-end wrench AF 7
−
Open-end wrench AF 8
Figure 5: Mounting the tip, schematic
1
Wrench flat of the tip
2
Wrench flat of the linear actuator
Mounting a tip
1.
Screw the selected tip by hand into the inner thread of the pusher (see figure above).
2.
If necessary: Tighten the tip further with a tightening torque of max. 2 Nm:
a)
Position an AF 7 open-end wrench on the wrench flat of the linear actuator.
a)
Position an AF 8 open-end wrench on the wrench flats of the tip.
b)
Screw the tip further into the pusher with the AF 8 open-end wrench.
3.
Make sure that the tip is affixed firmly.