phytron phyMOTION, Перевод с немецкого оригинала инструкции, Страница: 15 / 37

phytron
15 MA 1269-A007 EN
5 Installation
Phytron always delivers the phy MOTION ™ completely assembled in order to make sure
you can start with the installation and the wiring right away.
Further manual
Detailed information on this subject is in a supporting manual:
“ phy MOTION
TM
Modular Multi-axis Controller for Stepper Motors”
5.1 Mechanical Installation
In case you receive an individually packed I1AM01 as an expansion module or after repair
or service unpack the module in ESD predected area only.
CAUTION – Possible damage by ESD!
T he modules of the phy MOTION
TM
consist of sensitive electronic
components that can be destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD predective
packaging.
- Always handle the components in compliance with the ESD
predection measures.
- No liability is accepted for any consequences resulting from improper
handling or non-ESD-friendly packaging.
i
CAUTION – Possible damage!
The I1AM01/I1AM0a module is designed for a maximum supply voltage of
70 V
DC
. If it is supplied with >70 V
DC
the card might be damaged.
- Make sure that a power module (POWM01, POWM02) is supplied on
the left with less than 70 V
DC
to avoid damage.