phytron phyMOTION I4XM01.1, Перевод оригинального руководства

Страница: 23 / 25

phytron
23 MA 1279- A003 EN
7 Principles of Positioning
Information about positioning, see:
Further manual
Detailed information on this subject is in a supporting manual:
“Principles of Positioning of the Stepper Motor Controllers“
8 Service
In the case of a service order, please proceed as follows:
First try to identify the technical problem. Feel free to ask our support team for help. We
are pleased to assist you.
Removal of a module:
- Switch off the phy MOTION ™’s supply voltage
- Disconnect the supply voltage
- Cut the red seal tape and the black label tape carefully on the left and right edge of
the module/front panel which you want to remove. Don’t slide the blade between
the front panels by no means. When backfitting by our service the red seal tape is
renewed.
- Loosen the front screws to remove the common INAM01, EXAM01 and I4XM01
modules from the housing. They are connected with ribbon cables.
- Disconnect the connector (ribbon cable) that connects I4XM01 with INAM01 or
EXAM01.
- Exchange the I4XM01 module and reassemble it together with the INAM01 or
EXAM01 module.
- If you want to use the phy MOTION ™ after removing a module, the gap has to be
sealed with a blanking plate before power supply is reconnected and switched on.
- To send a module to phytron use ESD packaging only.