phytron phyMOTION I4XM01.1, Перевод оригинального руководства

Страница: 20 / 25

Manual I4XM01
MA 1279- A003 EN
20
6 Commissioning
Please read the manual for basic commissioning information of the INAM01 module:
Further manual
Detailed information on this subject is in a supporting manual:
“ phy MOTION
TM
Modular Multi-axis Controller for Stepper Motors”
The programming environment phy LOGIC
TM
ToolBox is explained in the following manual:
Further manual
Detailed information on this subject is in a supporting manual:
“ phy LOGIC
TM
ToolBox – Communication Software for the
phy MOTION
TM
Stepper Motor Controller“
For programming the sequential program please read:
Further manual
Detailed information on this subject is in a supporting manual:
“ phy LOGIC
TM
Command Reference for the phy MOTION
TM
Controller”
Information about positioning you’ll find in:
Further manual
Detailed information on this subject is in a supporting manual:
“Principles of Positioning of the Stepper Motor Controllers“
i
CAUTION – Possible damage!
Some modules are set to a default value on delivery. So e.g., the motor
current must be set to the corresponding value (see the motor data from
the motor manufacturer). Connected components like motors can be
damaged by incorrectly set values.
- Please check if the parameters are correct before starting.