phytron 10010115, Руководство пользователя

Страница: 23 / 56

phytron
6 Motor Connection
The following chapter gives a description of how to wire different types of 2-phase stepper
motors.
CLD
+
stepper motor controllers may be connected to stepper motors with
0.5 to 2 A
Peak
phase current.
The stepper motor winding resistance should be less than 10 Ohm for full power.
The winding inductivity of one phase should be less than 10 mH.
When using motors without basic isolation between motor winding and housing, the
maximum admissible supply voltage U
B
≤
37 V
DC
.
When operated with U
B
= 37...50 V
DC
the motors should have 40 V
r.m.s.
(or û = 57 V) basic
isolation design voltage (acc. to VDE0160 or EN50178).
Stepper motors with 8 leads can be connected with the windings wired in parallel (1) or
serial (2).
The wiring scheme (3) with serial windings is recommended for the 6-lead stepper motors.
If wiring scheme (3) cannot be used because of the motor construction, the motor may be
operated with only two of the four windings energized according to wiring scheme (4).
Stepper motors with 4, 6 or 8 leads can be connected to the controller.
5-lead stepper motors must not be connected to the CLD
+
.
Connecting a 5 lead stepper motor might damage the CLD
+
.
Please compare the motor data of the stepper motor with the adjusted current.
6.1 Motor Connector
Fig. 8: X2 Motor connector
21 MA 2112-A002 GB