[Removal is accomplished by first lifting the lamp base to release pins from
contacts.]
The flash tubes are polarized. Their base has two large pins and two small
pins. It will only insert one way. Place end of flash tube into spring
support, then insert base pins into socket. Please insert carefully to avoid
damage or injury.
With all lamps and flash tubes securely installed, replace diffusion panel (it
doesn’t really matter which side is in or out.) Panel may catch on lip of
frame. If required, turn unit on face to insert panel. Replace “L” bracket
and thumbscrews.
To set up the unit, first mount and secure it on a suitable stand. The Skylighter
stand adapter allows the unit to be mounted on a stand with a 3/8” to 5/8” post. Be
sure to use a stand that is stable and will not tip easily.
With power switch OFF, attach the cable to the circular input connector,
located on the back of the Skylighter, and connect the other end to the
purchased PowerLight power supply. See PowerLight instructions for
installation and operation.
PowerLight modeling light controls must be
set to FULL ON for Skylighter fluorescent modeling lamps to
function. Only then turn on the Skylighter power switch. THE
FLUORESCENT MODELING LAMPS ARE NOT ADJUSTABLE.
ANY ADJUSTMENT BY THE POWERLIGHT MODELING WILL
DAMAGE THE SKYLIGHTER INTERNAL BALLAST (S).
Power Input:
The power required to operate the Skylighter fluorescent lamps is 105 to 125 volts
AC, 60 Hz and this power comes from the PowerLight, through its’ line cord
Circuit Protection:
All circuit protection for the Skylighter is provided by the PowerLight power
supply.
Power switch:
The power switch controls only the modeling lamps.
Flash Power:
See the PowerLight power supply instructions. The Skylighter flash power is fully
controlled by all features and functions of the PowerLight power supply, to which
it is attached.
