14
Copyright © 2013 Alary Design / PhotoShip One LLC -
www.PhotoShipOne.com
Next you will need to configure the controller to accept the output from the RC receiver. Connect the
controller to the GUI. Go to the ‘Advanced’ tab. Make sure the RC Input Mapping settings are set as
shown. Figure 32. To control Roll/Tilt set as below:
Source - PWM
Roll - RC_ROLL
Pitch - RC_PITCH
Yaw - no input
To control Pan/Tilt set as below:
Source - PWM
Roll - no input
Pitch - RC_PITCH
Yaw - RC_ROLL
Figure 32. RC Mapping GUI
Under the ‘RC Control’ box you may make adjustments to each axis as it pertains to control from the RC
transmitter. Please refer to the SimpleBGC manual for details on what these settings do and how to
adjust them.