SG(AG) 300 control unit
Installation
75082(-)
17
6.2
Installation procedure
Before installing the SG(AG) 300 control unit, make sure that you are observing all of the safety no-
tices found in the "Safety notices to observe during installation" section.
6.2.1
Installation and dismounting for the control unit
There are four mounting holes in the SG(AG) 300 control unit which can be used to attach it to the
end product with the appropriate screws (for example, use screws meeting the requirements of DIN
EN ISO 7049 with Ø 4,8 mm and of suitable length: 6 mm plus the screw-in depth into the applica-
tion). The SG(AG) 300 control unit should be mounted so that it lies flat against its supporting mate-
rial. In the end product, no mechanical forces (such as torsion) should be put on the SG(AG) 300
control unit or its housing. Such forces could lead to damage (such as cracks) in the housing.
Figure 10
SG(AG) 300
control unit mounting points (in mm)
320
78
5,5
