SG(AG) 300 control unit
Installation
75082(-)
19
Opening the shield cover
Figure 11
Opening the shield cover on the SG(AG) 300 control unit
A
Shield cover
B
Locking clip
1
Pull out the mains plug from the outlet.
CAUTION
You should only connect and disconnect the cables when they are completely discon-
nected from any live current!
2
Use a suitable tool to loose the both locking clips, refer to figure 11.
3
Remove the shield cover.
4
You can now connect or disconnect a plug and socket. Be sure to use the proper socket, as
shown in the connection layout diagram (refer to page 9, figure 2).
5
Close off the unused sockets using dummy plugs
.
NOTICE
The dummy plugs ensure that the sockets are properly protected against IP66
splashed water.
A
B
B
