Operating the printer
107815_en_00
PHOENIX CONTACT
English
Settings
Changing printing parameters
Set heat level
When the printing quality is inadequate, you can change the value. We recom-
mend first raising the heat level via CLIP PROJECT (at: "File, Print Setup").
Only change the setting in the printer after this has been done. It results in an
additional increase.
0
Move print position horizontally
This can also be modified via CLIP PROJECT (at: "File, Print Setup"). The val-
ues from the printer and from CLIP PROJECT are added together.
0.0 mm
Move print position vertically
This can also be modified via CLIP PROJECT (at: "File, Print Setup"). The val-
ues from the printer and from CLIP PROJECT are added together.
0.0 mm
Print on request
Off: The next label is printed immediately
On: The next label will only be printed when the corresponding button is
pressed on the touchscreen.
Off
Repeat print by pressing the button
There are several setting options. You can repeat the identical print job or first
query the variable data
Edit
Label detection
Change procedure for detection of label sensor
If you are printing with media from Phoenix Contact, no adjustment is neces-
sary. Continuous media is automatically detected
Gap sen-
sor
Extrapolate labels
This functions prevents the first labels from remaining un-printed. In the default
setting, this function is on.
On
Warning before end of ink ribbon
Switch on/off the warning that the ink ribbon is almost at its end
If the remaining diameter of the ink ribbon roll is 32 to 74 mm, a warning ap-
pears on the display
Off
Table 3-1
Menu structure
Menu
Setting option [...]
Default
