Phoenix Contact 2313643, Руководство пользователя

Страница: 56 / 94

TC ETH EXTENDER S19
56
PHOENIX CONTACT 104273_en_01
5.3.1 DSL connection
For each Ethernet extender there is a corresponding DSL connection labeled "DSL x.3".
Figure 5-2 DSL connection
The devices are preset for 2-wire operation. As of firmware version 2.1, the device detects
the 4-wire installation automatically. If you set the correct operating mode using the config-
uration software PSI-CONF however, the connection is established twice as fast as with
automatic detection.
2-wire operation
Figure 5-3 2-wire operation, point-to-point connection
Single wires Port
Aa, Ab Port A
Ba, Bb Port B
NOTE: Malfunction
Never connect DSL port A to DSL port B of the same device (DSL loop).
In order to make data transmission less susceptible to interference, we recommend using
shielded twisted pair cables.
Bb Ba
Ab Aa
1
2
A
B
ETH
1.1
USB
1.2
DSL
B
A
1.3
PSI-MODEM-SHDSL/ETH
Ord.-No. 23 13 643
PSI-MODEM-SHDSL/ETH
Ord.-No. 23 13 643
3
A