Philips TPM15.3L, Руководство по обслуживанию

Страница: 12 / 81

Mechanical Instructions EN 12 TPM15.3L LA 4.
2015-Aug-07
back to
div.table
Figure 4-5 SSB removal
4.3.4 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.3.5 Speakers
1. Gently release the tapes that secure the speaker cables.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.3.7 IR/LED Board
1. Remove the stand bracket as described earlier.
2. Gently release the clips that hold the board and take it out
from the bezel.
3. Unplug both the connectors from the IR/LED board.
When defective, replace the whole unit.
4.3.8 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set..
When defective, replace the whole unit.
4.3.9 LCD Panel
1. Remove the rear cover as described earlier.
2. Remove the keyboard control panel as described earlier.
3. Remove the SSB as described earlier.
4. Remove the PSU as described earlier.
5. Remove the speakers as described earlier.
6. Remove the stand bracket as described earlier.
7. Remove the IR/LED board as described earlier.
8. Remove the WiFi module as described earlier.
9. Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
10. Remove all other metal parts not belonging to the panel.
11. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal
Instructions below apply to the 55PFG5100/78
.
4.4.1 Rear Cover
Refer to Figure 4-6 for details.
1. Remove the fixation screws [1] that secure the base assy,
pull out the base assy from the set. Then remove the
fixation screws [2] [3] [4] that secure the rear cover. Refer
to
Figure 4-6 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
19840_105.eps
1
3 3
2
2
3
3