Connecting to the DMX512 Network
9
SL NITRO 510 LED STROBE Luminaire
Installation & User’s Manual
Sh wline
CAUTION:
In the event the AC input cable of this luminaire is damaged, it must be replaced, by the user, with an
approved cable through an Authorized Showline Dealer or Service Center.
3. Connecting to the DMX512 Network
Basic DMX512 installation consists of connecting multiple SL NITRO 510 LED STROBE Luminaires together (up
to 32 luminaires) in "daisy-chain" fashion. A cable runs from the control console (or DMX512 control source) to the
DMX connector on the first SL NITRO 510 LED STROBE Luminaire. Another cable runs from the other DMX
connector on the first unit to a DMX connector on the next SL NITRO 510 LED STROBE Luminaire (or DMX512
device to be controlled).
Figure 5: SL NITRO 510 LED STROBE Luminaire DMX512 Input / Output Connections
Note:
For more information on DMX512 networking and systems, refer to
"Additional Resources for DMX512" on
page 1
. For SL NITRO 510 LED STROBE Luminaire DMX Mapping, refer to
"DMX CONTROL" on page 24
.
Figure 6: SL NITRO 510 LED STROBE Luminaire - DMX512 Connections
DMX512 / RDM Input
DMX512 / RDM Output
Back of Fixture
DMX512
DMX512
(out from first
to second luminaire)
DMX512 Connections
Note: Remaining pins on each connector are not used.
DMX512 Signal
XLR Pin
Common (Drain)
1
DMX512 -
2
3
(from console or
control device)
SL NITRO 510 LED
STROBE Luminaires
DMX512
(out to the next luminaire
or DMX512 controlled device)
